HP PRINTER 4025 ERROR 59.F0 [SOLVED]
Error 59.F0 displays in the HP printer 4025 while printing the document. This displays due to several reasons.
- Troubleshooting the few internal hardware of printer will bypass this error.
- Verify that the ITB (image Transfer Belt) installed properly.
- ITB rotating belt which carries the mixture of different colors of toner particles.
- ITB may be stuck and not able to rotate this causes the printer error 59.F0.
Reseat the ITB. To reseat the ITD, follow the steps below.
- Power on the device.
- Open the front door and remove all the cartridges, and then cover the cartridges to avoid excessive light exposure.
- Now open the upper right door of the printer.
- Grasp the blue lever on both sides, and apply slight pressure to pull ITB towards you at a downward angle.
- Pull the ITB out of the device until two large handles expand. If the ITB flag is damaged or broken, replace it with a new one. Check if the ITB gear is working correctly.
- Lift the ITB and tab gently by holding the handles. That cause dirt and waste toner fall from the ITB.
- Reinstall ITB gently back into place.
- Grasp and push the ITB on the printer so that it fits in its place.
- Place the cartridges in position and close the front door.
- Now the ITB which is stuck will rotate freely and the printer will work properly.
If the problem persists, contact customer Technical service @Toll-Free Number 1-877-220-4708 for further assistance.
Comments
Post a Comment